The workshop heating is done by a large forced-air gas heater hanging near the rear of the workshop.
It is control via the 'CodeShield Thermodyne 5000' or electronic thermostat which is located
beside the middle workshop door. See below for operating instructions.
The Classroom is heated with an electric baseboard heater under the large window.
It's not a very efficient heater. It won't heat the room very quickly or to a comfortable level.
There is a separate thermostat for it located near the middle door.
Make sure to turn the thermostat completely OFF when you leave.
There is no direct heating of the Cleanroom area.
CodeShield Thermodyne 5000
aka : The Furnace Controls
How to operate :
The temperature can be check by monitoring LED2. The RGB LED will blink out the
temperature every 5 seconds.
First it will blink the tens, then pause, then blink out the ones.
For a Temperature of 21C you will see 2 blinks, a pause, then 1 blink.
You will get an extra pause for the number 0.
The colour of LED2 matters. A GREEN blink indicates that the CodeShield Thermodyne
5000 is not in a heating cycle. a RED blink means that it is currently in a heating cycle.
The CodeShield Thermodyne 5000 will maintain a minimum temperature of 10C all times.
"But 10C is too cold for normal humans" I hear you say!
Pressing BUTTON will start the heat cycle for 1 hour. During the heat cycle you
will see LED1 lit to indicate a heat cycle is in progress. You will also notice that
temperature of 21C will be maintained. LED2 will change between GREEN and RED
as the furnace maintains 21C.
As long as LED1 is lit the heat cycle will continue and the furnace will maintain 21C.
The heat cycle will only last 1 hour from time you press BUTTON. After 1 hour the
CodeShield Thermodyne 5000 will return to the minimum temperature of 10C.
There is an alarm at 15 minutes left in the heat cycle to warn you. You can press BUTTON
after the alarm to start another 1 hour heat cycle.
To reset the heat cycle press the RESET button and the CodeShield Thermodyne 5000
will go back to maintaining a minimum temperature of 10C.
None of the other CodeShield functions work. But you may play with the knobs if you like!